Praktikus-Wall pivoting crane

The Praktikus-wall pivoting crane is deigned in accordance with the EU-machine guidelines of the newest DIN 15018 H2 B2 an it is in accordance with the VDE and UVV regulations. The crane arm has bush bearings and can be easily swiveled by hand. All components are steel flint derusted by a machine and are covered by a green primer, REAL 6018, while the console is black REAL 9005. The design is especially wrap resistant and has a swivel range of 180°.

Crane consisting of stable standardbearing consoles and crane arm (disassembled) without fastening screws. Delivered with. Electrical chain hoist, Katzfahr-end stops and complete crane documentation consisting of crane test book, installation, maintenance and operating instructions.

Basic electrical system:

 Lockable design-Line disconnecter, Round cable-Power supplied in the crane area with cable stay tube up to 3000 mm projection, above 3500 mm projection with round/trailing cable feed.

In addition to the installed contactor control, the overload protection is provided by a friction clutch and standard electrical lift limit switches fro the highest hook position. They must not not be started under normal operating conditions. The electrical chain hoist will be attached at a manual carriage. Operating and control voltage 400 V/50 Hz/ 48 V.

• Lift emergency switch-off for operational start-up of the load hook in the highest hook position
• Electrical carriage
• hot dip/painted for use in the open air